Draw Analysis Of Boiler Flue Gas
HOT
Capacity:1-20t/h
Rated thermal efficiency: 100-104%
Fixed working pressure: ≤1.6MPa
Applicable fuel:natural gas etc.
HOT
Capacity:0.7-14MW
Rated thermal efficiency:96-98%
Fixed working pressure:≤1.25MPa
Applicable fuel:Natural gas, light oil, etc.
HOT
Capacity:0.7-2.8Mw
Rated thermal efficiency: 97.2-106%
Fixed working pressure:0.1MPa
Applicable fuel:Natural gas, etc.
HOT
Capacity:2.8-7.0Mw
Rated thermal efficiency:≥105.5%
Fixed working pressure:-0.02MPa
Applicable fuel:Natural gas, etc.
HOT
Capacity:99Kw
Rated thermal efficiency:97.2-104.4%
Fixed working pressure:1.0MPa
Applicable fuel:Natural gas, etc.
HOT
Capacity:0.5-4.0 t/h
Rated thermal efficiency:98%
Fixed working pressure:≤1.25MPa
Applicable fuel:electric energy
A periodic boiler flue-gas analysis is the best indicator that an adequate supply of combustion air exists. This, and any necessary burner adjustments, should be performed by a trained technician with the proper equipment to measure the amount of excess oxygen and/or carbon dioxide and ppm of carbon monoxide.Get Price
Flue gases are the gases that are released into the atmosphere by a flue, or pipe, from the steam boiler. Many biofuel feedstocks such as corn, sugarcane, and soybeans are also key sources of food for millions of people.Get Price
A periodic boiler flue-gas analysis is the best indicator that an adequate supply of combustion air exists. This, and any necessary burner adjustments, should be performed by a trained technician with the proper equipment to measure the amount of excess oxygen and/or carbon dioxide and ppm of carbon monoxide.Get Price
Flue gas Analysis : Zirconium Probe Oxygen analyser Unburnt Analysis : Gravimetric Analysis Temperature : Thermocouple Since expansion in turbine is an adiabatic process, the entropy is constant. Hence draw a vertical line from inlet point (parallel to y-axis) upto the condensing conditions. Coal consumption of the boiler = 1550 kg/hr Get Price
- Direct steam-type humidifiers inject boiler-generated steam directly into the air stream. These systems normally operate above 70 degrees C (158 degrees F), and Legionella cannot survive at that temperature. - Atomizing humidifiers use mechanical devices or pneumatic air to create a water mist that evaporates into the air stream.Get Price
The flue gas enters the bottom of the absorber with the lean amine solvent introduced at the top of the absorber. The lean amine enters with a loading of 0.1-0.12 and leaves with a loading close to 0.45-0.55. The rich stream from the lean-rich heat exchanger is fed to the regenerator. The regenerator is a packed column with a kettle reboiler.Get Price
Flue gas Analysis : Zirconium Probe Oxygen analyser Unburnt Analysis : Gravimetric Analysis Temperature : Thermocouple Since expansion in turbine is an adiabatic process, the entropy is constant. Hence draw a vertical line from inlet point (parallel to y-axis) upto the condensing conditions. Coal consumption of the boiler = 1550 kg/hr Get Price
To increase the efficiency of a boiler by 2 to 3 percent, install an economizer. This device preheats the feedwater (returned condensate). In the case of a 250-horsepower boiler, an initial investment of $6,000 provides an annual savings of more than $3,000.Get Price
Fire-tube boiler Here, water partially fills a boiler barrel with a small volume left above to accommodate the steam (steam space).This is the type of boiler used in nearly all steam locomotives.The heat source is inside a furnace or firebox that has to be kept permanently surrounded by the water in order to maintain the temperature of the heating surface below the …Get Price
The flue gas enters the bottom of the absorber with the lean amine solvent introduced at the top of the absorber. The lean amine enters with a loading of 0.1-0.12 and leaves with a loading close to 0.45-0.55. The rich stream from the lean-rich heat exchanger is fed to the regenerator. The regenerator is a packed column with a kettle reboiler.Get Price
UNIT I Water: Specifications for water, analysis of water – alkalinity, hardness and its determination (EDTA method only). Water for domestic use, Water softening processes – Lime – Soda process, Ion exchange method, boiler feed water, boiler problems-scale, sludge, priming and foaming, caustic embitterment and corrosion, their causes and prevention, removal of silica, …Get Price
Feel free to reach out if you want to collaborate with us, or simply have a chat.
